#Molex 8 pin connector kit upgrade
#Molex 8 pin connector kit series

The HF+ and HF- pins also power the illumination LEDs. Out- pin on your chosen print fan output (eg OUT4) Out- pin on your chosen hot end fan output (eg OUT5)įAN- pin on your chosen print fan output (typically FAN0) V_OUTLC pin on your chosen print fan output (eg OUT4)įAN- pin on your chosen hot end fan output (typically FAN1) V_FAN pin on your chosen print fan output (typically FAN0) V_OUTLC pin on your chosen hot end fan output (eg OUT5) V_FAN pin on your chosen hot end fan output (eg FAN1) The pins are labelled on the underside and should be connected as follows: Label The power connector (Input 1) is a 2 x 3 pin black Molex Microfit 3 connector. Optional depending on which kit you purchase, Different lengths available from The ones with machined Delrin ends are best. Optional depending on which kit you purchase, Also available from ĭelta printer arms with magnets in the end and socket to fit the ball studs. Note this was produced for Duet3D by e3d, originally with a 1.0 pitch, the more recent e3dv6 threaded heatsinks are 1.5mm pitch.

Pitch is either 1.5 or 1.0, see the note on the heatsink Not needed if your Smart Effector uses a 2-pin Microfit connector for the heater instead of a terminal block - They are supplied with a terminal block by default Small ferrules for terminating heater wires

Smart Effector SMT Component Clearances.

The firmware source files are published here: ¶ Physical properties ¶ Dimensions If you supply 12V for the hotend cooling fan you need to bridge the 'on for 12V' jumper or else the LEDs will be dim. The print illumination LEDs run off the same circuit as the hotend cooling fan (so they come on when the hotend cooling fan is on). Note: The Smart Effector can be supplied with either 12V or 24V for the hotend heater, hotend cooling fan and print cooling fan.

#Molex 8 pin connector kit series

Programmable nozzle contact sensitivity when used with Duet series electronics.

3.3V or 5V supply needed for nozzle contact sensor.

Compatible with 12V and 24V heaters, and 12V and 24V hot end fan power (jumper selectable, see note below).

Carriage Adapters suit carriages with 4 x M3 fixing holes in a 20mm square.

Smart Effector and Carriage adapters suit magnetic ball studs with M3 tails.

#Molex 8 pin connector kit upgrade

If you already own a E3D Lite6 hot end, you will need to order a heat break to upgrade to a full V6 hotend using the threaded heatsink.Compatible with E3Dv6 threaded heatsink ().Compatible with e3d Revo Micro with the screw top heatsink.Support for thermistor, or 2-wire PT100 temperature sensor with 2- or 4-wire connection back to electronics (version for 4-wire PT100 sensor available to special order).Connectors on underside for hot end heater, hot end fan, print cooling fan and temperature sensor.Power and signal connectors on top for connection to the 3D printer control electronics, to make removal of the hot end easier.Matching PCB Carriage Adapters ensure uniform spacing between bearings at top and bottom of the rods, for accurate nozzle motion.Amber LED to indicate power to hot end heater.Green LED to indicate Z probe triggering and successful programming.Three white LEDs to illuminate the bed whenever the hot end fan is powered.Built-in nozzle contact detection (Z probe).Note: the metal carriage and belt tensioner on the carriage adaptor plate is not part of the kit.